1-PC Self-Priming Electric Drill Powered Water Pump Home Garden Pumping

Description

Product Material: Engineering Plastic
Working temperature: 5°~49°C (41°~120°F)
Drive mode: electric drill drive
Inlet/outlet inner diameter: 16MM
Inlet/outlet diameter: 19MM
Product accessories: water pump*1, tube binding ring*2, screws*2, tripod*2
Uses: Used for water supply and drainage
Before you buy
1. In order to achieve the best start-up and extend the service life, add a small amount of lubricating oil at the pump inlet before use
Rinse with clean water after each use.
2. Make sure the inlet hose is sealed and as short as possible, the hose should not exceed 9 inches (2.75 meters).
3. Working in the temperature range of 5°~49°C (41°~ 120°F).
4. When pumping abrasives or liquids containing solids, use a filter on the inlet line to get longer
Pump life.
5. It is recommended that the pump stand be fixed on the surface for easy use.
6. Install and start working, observe the inlet pipe to ensure that the fluid is sucked into the pump within 15-20 seconds,
If not, check whether the inlet pipe is correctly installed on the inlet pump, do not run dry,
If the pump fails to start, check to ensure that the hose is not kinked or clogged, the pump depends on the pump
The fluid is lubricated.
7. It is recommended that the rotation speed be in the range of 1500~3500 rpm. The head and flow are all related to the rotation speed.
The head and flow are also high.